1. Press the Lighting Icon on the screen, 

2. Hold down in the bottom right position within the touch screen area for few seconds = Program bar should appear. 

2. Choose the "Zigbee Set up"  option 

   Now the monitor will broadcast the Zigbee NET value. 

4. On the screen choose the Light you wish to Pair = the icon will change to blue

5. Press the Digitex you wish to Pair to that icon on the screen - Wait 10 seconds

6. Repeat for each room 

 


7. Once Finished press "zigbee exit" on touch screen 


NOTE: 

The screen will time out after 2 minutes from "Zigbee set up" mode.


Do not attempt to program if another property close by is also in programming mode, as the Digitex may be programmed to the wrong screen.