1. First the Digitex switches need to be programmed with the same NET (Zigbee) as the Touch Screen Monitor.
2. Press the Lighting Icon on the screen,
3. Hold down in the bottom right position within the touch screen area for few seconds = Program bar should appear.
4. Choose the "Zigbee Set up" option
Now the monitor will broadcast the Zigbee NET value.
5. On the Digitex Light Switch hold down "Reset" and "Set" together, Release the "Reset" and then 1 second later "Set"
The Digitex will then flash 5 times when it has received the new NET from the Touch Screen.
6. Once Finished press "zigbee exit" on touch screen
NOTE:
The screen will time out after 2 minutes from "Zigbee set up" mode.
Do not attempt to program if another property close by is also in programming mode, as the Digitex may be programmed to the wrong screen.
If the Digitex did not flash 5 times then check another switch within the property.